Work-sharp WS3000 Custom Tool Bar Jigs Manuel d'utilisateur télécharger pdf (Page 2)

This is a simple jig to set up the angle I like for my

round nose scrapers. Provides a fast and consistent

way to regrind my scraper. I have various jigs for

each specific scraper.

Small round nose scraper holder for my

Sorby swan neck hollowing tool tip.

Simple scrap with two ¼ inch holes in

it. Top one is tapped for wing bolt.

Sharpen as you would any round nose

scraper.

When used with the Tool Rest, it provides a fast

and consistent grind. The angle setting jig (as

shown above) can be used to create various,

repeatable grind angles.

Lay the wooden jig flat onto the Tool Rest and

make full sweeps, side-to-side, until a consistent

and sharp edge is acheived. Grit changes can be

made without modifying the set up.

ROUND NOSE SCRAPER JIG

1 2 3

Pas de commentaire

Work-sharp WS3000 Custom Tool Bar Jigs Manuel d'utilisateur Page 2