Work-sharp WS3000 Tool Bar Attachment Manuel d'utilisateur télécharger pdf (Page 10)

Roughing Gouge

(11) Multi Jig Tormek® SVS-50 with Roughing Gouge

Use Vee Plate fixture when sharpening

Roughing Gouges

See Roughing Gouge Set Up Chart

(Section 10) for preset grind angles.

Or set the TSO and H to match the existing angle.

Record on the Data Chart in section 7.

Technique:

Roll the tool from one side to the other on the Tool Bar in a

smooth, steady motion. This will create a consistent grind

pattern and provide the sharpest, most consistent cutting

edge.

Do not start grinding in the center of the tool. Begin at one

side and smoothly roll the tool to the other edge. Check

edge for grind pattern and sharpening progress after every

other pass.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Work-sharp WS3000 Tool Bar Attachment Manuel d'utilisateur Page 10