Work-sharp Sharpening System Manuel d'utilisateur télécharger pdf (Page 29)

Be sure to mount the abrasive with the

slots aligned with slots in the plate so you

can see clearly the cutting edge while you

work. Some will ﬁnd it easier to align the

abrasive to the disk as shown above,

while others will ﬁnd it easier to align the

disk to the abrasive as below. I tend to

use this latter method.

As with the abrasives on the solid plates,

I like to mark the grit on the abrasive side

near the center so I can see at a glance

which grit is mounted. If you could blow

up this small photo to full-size you

would see the P1200 is on the right

and the P400 is on the left.

The slotted wheel mounts on the

same shaft using the same thumb screw

as the glass plates. Once in place and

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 35 36 37

Pas de commentaire

Work-sharp Sharpening System Manuel d'utilisateur Page 29