Work-sharp WSKTS-KO KNIFE & TOOL SHARPENER User Guide Manuel d'utilisateur télécharger pdf (Page 21)

NOTE:

Tools such as these

do not require sharpening to

a precise angle; just let the belt

conform to the edge of the tool. It will

take longer to restore an edge to

severely damaged tools.

Best Techniques:

• Always clamp or fixture work piece before grinding for optimum safety.

• Let the tool do the work. Do not overload the tool during grinding. Abrasive

selection and belt speed are already optimized.

• Only sharpen tools on the right hand / downhill side of the belt.

• Tool Grinding Attachment available for heavier grinding tasks (see Section 12).

Remove Sharpening Guide. Pull up firmly.

Ensure the Edge Guide is in the raised position and

that the Knife Sharpening Guide has been removed

before grinding.

Push Cassette Lock Release Lever to rotate cassette

to grind mode.

Use the P120 belt and high speed for light

sharpening and grinding tasks.

Grinding, Polishing, Deburring

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28

Pas de commentaire

Work-sharp WSKTS-KO KNIFE & TOOL SHARPENER User Guide Manuel d'utilisateur Page 21